I was recently embarrassed at a presentation that I gave when asked for my business card.  Sadly did not have one to give.  Well no more!  Here is my new card.  I used the z-stop function on my printer to force a filament change at 1mm.  So far, everyone that I show it to has loved it.  It is a bit of an expensive card.  It cost $0.175 of material and 22min of printing.  Definitely not a card that I can give out en masse and is more of a card to impress.  The semi-transparent natural filament allow the text to standout even more (but is hard to capture in a picture)